CNC marking tool MarkingStar
CNC marking tool

• Process-integrated marking and labelling
• Suitable for marking a wide variety of materials
• Surface is compacted and reinforced, not weakened or damaged
• High level of wear-resistance for a long service life
• Also suitable for thin-walled workpieces
• Burr-free marking line
• High-quality lettering
• Compensates for workpiece unevenness
• Also suitable for marking round surfaces (up to 15°)
• Depending on version, can be used to mark surfaces with a hardness of up to 50 HRC
• Generates no noise
• Save money – over 75 % less time spent on marking
• Note: The greater the eccentricity and the higher the spindle speed (or the lower the feed rate), the deeper the marking. The rule of thumb for clean lettering is: Feed (mm/min) x 10 = spindle speed (rpm)
• Held by Weldon holding fixture or 12 mm collet for the Slimline and Small versions
• Held by Weldon holding fixture or 20 mm collet for the Medium, Large and Extra Large versions
• Change needles in a flash: The marking needle is pulled out and changed using pliers. This is also an advantage if the needle slips or breaks off