Zero adjuster, height 50 mm

• For setting machine reference points
• The adjustment device is placed on the workpiece and the tool (e.g. milling cutter) moved towards the spring-mounted contact surface until both pointers on the dial indicator are at zero. The lower edge of the tool is now positioned at exactly 50 mm ± 0.01 mm. The reference dimension of 50 mm is entered into the machine control system.
  Caution: Process may only be performed while the tool is stationary.
• Base body and probe insert are case-hardened (60 HRC) and finely ground
• Two guide diameters for optimum handling of the contact surface
• 558020 0005: six magnets in the base, plane-ground
• Supplied in a wooden case with dial indicator, operating manual and measurement log

Zero adjuster, height 50 mm

• For setting the reference point in the machine
• The adjustment device is placed on the workpiece and the tool (e.g. milling cutter) moved towards the spring-mounted contact surface until both pointers on the dial gauge are at zero. The lower edge of the tool is now positioned at exactly 50 mm ± 0.01 mm. The reference dimension 50 mm is entered into the machine control system.
  Attention: Process may only be performed while the tool is stationary.
• Base body and probe tip are case hardened (60 HRC), finely ground
• Two guide diameters for optimum handling of the contact surface
• 558020 0005: six magnets in the base, surface ground
• Supplied with dial gauge, operating manual and measurement log