PDC ISO indexable cutting inserts

• Polycrystalline diamond (composite cutting material) with carbide base, good cutting edge sharpness and low cutting pressure with narrow tolerances.
  Lower wear resistance with increased toughness.
  
• PDC CB1, fine grain
  Fine finishing and finishing of all non-ferrous metals and non-ferrous materials with a low percentage of or no abrasive fillers.
  Positive geometry for finishing and superfinishing machining, ap from 0.05 mm to 1.5 mm. Suitable for the narrowest tolerances with the lowest cutting pressure.
  For use with thin-walled and unstable workpieces.
  
• PDC-S CB2, rough grain
  Finishing and fine finishing of all non-ferrous metals and non-ferrous materials with low to high percentages of abrasive fillers
  Slightly negative geometry for semi-finishing, finishing and super-finishing machining, ap from 0.5 mm to 2 mm. Increased cutting pressure ensures improved surface finish quality at the narrowest tolerances.
  For use with thick-walled and solid parts under stable conditions.
  
• Other geometries and versions available on request, also without chip breaker

CCGT