SARA-DRILL cutting edge ASP30 120mm for boring head D-120 

SARA-DRILL cutting edge ASP30 120mm for boring head D-120
SARA-DRILL cutting edge ASP30 120mm for boring head D-120 SARA-DRILL cutting edge ASP30 120mm for boring head D-120 SARA-DRILL cutting edge ASP30 120mm for boring head D-120
Description
SARADRILL solid drilling tool
  • Machining of bore holes from Ø 49 to 270 mm
  • For machines with low drive power
  • Low-vibration, equipment-friendly machining with up to 50 % less drive power
  • Drilling in a single operation without centring and pre-drilling
  • No front face planing required
  • Cost-efficient boring system, since differences in diameter of up to 30 mm can be machined with one boring head by changing the cutting edges
  • Variable drilling depths of up to 15 x D due to holding fixture system with pluggable extensions
  • Internal coolant supply directly to the cutting edge, no high-pressure pump required
  • For rotating tools, the coolant is supplied via a coolant ring
  • Short chips due to chip-separating grooves in the roughing blade, no chip removal, even with extremely deep bores
  • Also for use on vertically operating machines
  • Low tool costs as wear is limited to the cutting edges and centre bit
  • Unproblematic regrinding of the centre bit and the cutting edges (in pairs) using the grinding fixture or the tool grinding machine
  • Cutting material:
    Cutting edge HSS-E-PM ASP30, ASP30 TiN
    HSS centre bit
  • For use on all machine tools as a rotating or stationary tool especially for machining large bore diameters on machines with low drive power
  • Caution: Not suitable for boring out existing holes!

SARADRILL cutting edge
  • For SARADRILL solid drilling tools
  • The cutting edges are delivered in pairs, i.e. 1 roughing blade and 1 finishing blade.
  • Note for machining blind holes:
    The finishing blade can be adjusted from 3 to 10 mm, depending on the size of the drill head, to machine intermediate dimensions. (Not permissible for machining through-holes!)
  • Caution: The cutting edges may only be replaced in pairs to prevent the risk of breakage!
  • Prices per pair (1 roughing blade and 1 finishing blade)

Article no./ATORN no.
1045500120
Packaging unit
1
Catalogue page
KS-0230
Cutting values
SW-0381
Stock status
in stock
Price:
369,00 € (440,00 € catalogue price / 16% saved)
valid until: 30.06.2024
Add to shopping cart
Tool Finder

Technical characteristics

Cutting data Cutting material D Designation
Cutting angle Information - yes HSSE-PM 120 mm D-120

Usage characteristics

aluminium < 8 % Si brass short hardened steel ≤ 65 HRC stainless steel austenitic stainless steel ferrit./martens. steel < 1000 N/mm² steel < 1400 N/mm² steel < 700 N/mm² superalloys Fe/NiCo based < 30 HRC superalloys Fe/NiCo based ≥ 30 HRc titanium alloys

very suitable suitable

Catalogue page Download
Cutting values Download

Delivery within EU countries:

Austria, Belgium, Bulgaria, Croatia, Czech Republic, Denmark, Estonia, Finland, France, Greece, Great Britain, Hungary, Ireland, Italy, Latvia, Lithuania, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden.

 

Delivery costs

Delivery costs depend on the order value.

- for orders less than € 100,- delivery costs € 22,-

- for orders over € 100,- delivery costs € 11,-

 

Exceptions

Unless otherwise stated, the delivery of bulky or heavy-weight items such as granite plates without special agreement in principle from Ratingen, Germany or directly from the manufacturer with additional shipping costs, excluding packaging.