SARA-DRILL drill head A2-65 55-65mm

Price:
799,00 €
(919,00 € catalogue price / 13% saved)
valid until: 30.06.2024
prices excl. vat plus shipping costs

Stock status
in stock

Ordered by 19:30 - delivered tomorrow.

SARADRILL solid drilling tool
  • Machining of bore holes from Ø 49 to 270 mm
  • For machines with low drive power
  • Low-vibration, equipment-friendly machining with up to 50 % less drive power
  • Drilling in a single operation without centring and pre-drilling
  • No front face planing required
  • Cost-efficient boring system, since differences in diameter of up to 30 mm can be machined with one boring head by changing the cutting edges
  • Variable drilling depths of up to 15 x D due to holding fixture system with pluggable extensions
  • Internal coolant supply directly to the cutting edge, no high-pressure pump required
  • For rotating tools, the coolant is supplied via a coolant ring
  • Short chips due to chip-separating grooves in the roughing blade, no chip removal, even with extremely deep bores
  • Also for use on vertically operating machines
  • Low tool costs as wear is limited to the cutting edges and centre bit
  • Unproblematic regrinding of the centre bit and the cutting edges (in pairs) using the grinding fixture or the tool grinding machine
  • Cutting material:
    Cutting edge HSS-E-PM ASP30, ASP30 TiN
    HSS centre bit
  • For use on all machine tools as a rotating or stationary tool especially for machining large bore diameters on machines with low drive power
  • Caution: Not suitable for boring out existing holes!

Boring head
Article no./ATORN no.
1045010065
Packaging unit
1
Catalogue page
Cutting values

Technical characteristics

Coolant supply Internal
Cutting data Cutting angle Information - yes
D 55 - 65 mm
Designation A2-65
Max. drilling depth (D) 15xD